photo

Details

This presentation will be a brief introduction to using the 150-watt laser cutter/engraver at Rockford MakerSpace, and will include a very brief overview of vector-based drawing programs and the laser hardware itself. Each attendee will take home a laser-cut/engraved souvenir. The presentation should last about one to two hours.

This presentation is FREE TO MEMBERS of Rockford MakerSpace.

Note that Rockford MakerSpace membership is NOT required to attend this presentation, or to use the laser cutter/engraver during this event, but membership IS required to do so outside of this presentation. Please see our wiki for membership information.

Space is limited. Please register now to reserve your spot!

NOTE: Registration closes 4 hours prior to the start of the event.

  Register for Intro to Laser Cutting/Engraving   Friday, July 1, 2022 7:00 PM  

Full name of person attending:
Only one person per registration please!
Email address:
Phone:
Enter 10 digit numbers only, no spaces or punctuation!
  Notify me of upcoming events[1]
  I am a current RMS member[2]

[1] If you check this box, we will add you to our mailing list. You may unsubscribe at any time.

[2] Do not check this box unless you are a member registering at a reduced rate. If you check this box and are not a member, you will be charged the price difference upon arrival at the event, OR your registration may be canceled.

TERMS & CONDITIONS

  • Please notify us via email at info@rockfordmaker.space at least 48 hours prior to the event if you wish to cancel. Refunds will NOT be issued if cancellation notice is not received at least 48 hours prior to the event unless the event is canceled by us.
  • Public events may be canceled due to low enrollment, severe weather or other unforseen circumstances. Full refunds WILL be issued in that case.
  • Attendees must agree to abide by the Rules and Guidelines^.
  • Rockford MakerSpace reserves the right to refuse participation to any person at any time.